Fume Purification Integrated System is suitable for catching dry non -fibrous particle -shaped dust. The main feature is that the cylinder is composed of a pouring pipe, exhaust pipe, cylindrical, cone and gray bucket. Fume Purification Integrated System is simple, easy to manufacture, installed and maintained, equipment investment and operation costs are low, thereby reducing the possibility of short circuit to exports in the center of the dust -containing gas self -tube body, and a conical reflex screen Prevent the two airflows from rolling up the dust that has been separated, and is brought out by the ascending airflow. It has been widely used to separate solids and liquid particles from the air flow, or is separated from the liquid to separate solid particles. Under normal operation conditions, the centrifugal force on the particles is 5 to 2500 times the gravity, so the efficiency of Fume Purification Integrated System is significantly higher than that of the gravity sedimentation room, which improves the dust removal efficiency.
Because Fume Purification Integrated System captures dry non -fibrous granular dust and smoke dust removal, it is usually applicable to industries such as metallurgy, casting, building materials, chemical food, cement, and cement.
Fume Purification Integrated System's working principle in the exhaust gas treatment equipment is to rotate the dust -containing air flow, separate from the airflow of centrifugal force from the airflow and capture it on the wall of the device, and then use the gravity to make the dust particles fall into the ash bucket. The centrifugal force on the particle is 5 to 2500 times the gravity, so the efficiency of Fume Purification Integrated System is significantly higher than the gravity settlement room. Most of them are used to remove particles of more than 0.3 μm, and the multi -tube Fume Purification Integrated System device also has a dust removal efficiency of 80-85%for particles of 3 μm. The smaller the width of the import tube is, the thinner the importing air is in the radial direction, the more conducive to the separation and settlement of the cylindrical cylindrical, the higher the dust removal efficiency; the width height ratio is 1: 2. Fume Purification Integrated System exhaust pipes are all round pipes, which are essentially extending the endor. The deeper the exhaust pipe is inserted, the greater the resistance of the equipment, the higher the dust removal efficiency; the deep depth of the intake pipe is too shallow, and the short circuit phenomenon will occur, causing the dust particles to be separated from the lower mouth of the inner cylinder. Generally, the depth of the exhaust cylinder should be aligned with the lower edge of the air intake pipe or slightly lower. The sealing device in the ash unloading has dual functions of unloading and sealing.
Fume Purification Integrated System structure is simple compared to other dust collectors structures, easy to manufacture, install and maintain management. Equipment investment and operation costs are low.
Note: Before running, the exhaust gas treatment equipment checks the confinement of the dust collector and the flue, the dust collector and the ash bucket, the ash bucket and the ash drainage device, and the ash motion device to eliminate the ash and air leakage phenomenon. Guanxiao baffle valve, gradually start the ventilation fan and no abnormal phenomenon. When the dust efficiency meets the design requirements, it is necessary to ensure the strictness of the gray mouth and to ensure the strictness of the gray mouth. It will flow at the bottom, causing excessive wear of the cone.
fume purification integrated system https://www.kaisenfilter.com/About.html
